- Single-component self-etch adhesive needs no mixing
- 5 mL bottle supports direct restorative bonding
- Self-leveling formula forms an 8 micron film
- Bonds to cut and uncut enamel and dentin
- Fluoride-releasing formula supports bonding workflow
- Quantity: 1 per Pack
Tokuyama Bond Force Refill, 5 mL Bottle is used for bonding light-cured or dual-cured composite restorative materials to cut or uncut enamel and dentin with a single-component self-etch adhesive. The refill supports direct restorative procedures that require a simplified bonding sequence without separate etching, rinsing, or component mixing.
During a Class I, Class II, Class III, Class IV, or cervical restoration, the adhesive is applied directly to the prepared tooth surface, rubbed across enamel and dentin, air dried, and light cured before placement of the restorative material. Bond Force can also be incorporated into repair procedures involving fractured composite or porcelain when the appropriate surface treatment is performed. Its one-bottle format helps maintain a streamlined adhesive workflow while supporting consistent coverage across cavity surfaces and margins.Each pack contains 1 bottle with 5 mL of Tokuyama Bond Force self-etch adhesive.
Dental offices ordering self-etch bonding adhesive from their supplier can buy this bottle refill for practices already using the Bond Force system, since the single-component formulation eliminates the need to combine separate liquids before application and provides approximately 5 minutes of working time after dispensing. Bond Force uses self-leveling technology to form a uniform adhesive film approximately 8 microns thick. The material is rubbed onto prepared enamel and dentin for at least 20 seconds, followed by gentle air drying for about 5 seconds and stronger air for an additional 5 seconds or longer.
The adhesive is then light cured for at least 10 seconds before restorative placement. The formulation also provides fluoride release and is designed to bond to both cut and uncut enamel and dentin.Bond Force works by combining self-etch conditioning and adhesive infiltration in a single application step, allowing the material to interact with the tooth surface while establishing a thin bonding interface. Its self-leveling consistency helps distribute the adhesive evenly over internal walls, margins, and irregular preparation geometry, reducing the likelihood of excessive pooling.
The one-bottle system supports a repeatable application sequence without separate mixing, while the thin cured film helps preserve restorative fit and margin control. This 5 mL refill is distinguished by its single-component chemistry, approximately 8 micron adhesive layer, fluoride-releasing formulation, compatibility with enamel and dentin, and defined rub-air-light cure technique for direct restorative bonding.
